RF Engineer Resume Samples

RF Engineer is also known as radiofrequency engineers, and the job role of these engineers is to specialize in those devices that transmit or receive radio waves. The roles and responsibilities listed on successful RF Engineer Resume are broken down into the following tasks – running constant evaluations on network KPI’s to optimize the performance of current wireless networks, designing RF schematics for developing a new wireless network, ensuring that the regulatory standards are met, analyzing equipment and identifying areas for improvement, and communicating data using the digital software.

As this position is a highly technical one, the RF Engineers are supposed to depict the following skills in their resumes – active listening and comprehension skills, the ability to understand and analyze wireless network KPI’s; RF design circuitry skills, knowledge of cell site design, LTE networks, proficiency in MS Excel, and experience with software such as Atoll, or Sierra. An engineering degree in electronics, telecommunications or the related is commonplace among RF Engineers.

 

RF Engineer Resume

Summary : 7 years of experience as RF Engineer and Software, my experience as Radio Network planning, design and optimization for GSM and UMTS systems. Over 4 years of experience working for mobile cellular networks with significant experience in the radio network planning and optimization.

Skills : MAPINFO 7.1, Net Act 4.0.,Google Earth, CAM 350 10.0,C, C++, SQL, PL/SQL.

Description :

    1. Designed two stages, low noise amplifier with source inductive degeneration impedance matching circuit for better synthesis with 50ohm Antenna output with minimum noise figure.
    2. Design improved gain by 33% under a common emitter second stage.
    3. Compared two-stage single ended amplifier with folded cascade trans conductance amplifier for gain activity in Cadence specter CAD tool.
    4. Created floor plan for operational amplifier to meet performance and size criteria.
    5. Success fully implemented RF Gilbert Mixer analyzing 3db compression point and conversion gain to determine optimal noise figure based on down conversion techniques.
    6. Modified voltage controlled oscillator (VCO) design for wide frequency range to reduce power consumption as low as 5mW implementing LC tank circuit.
    7. Analyzed low power consumption receiver design for low noise, wide frequency range and high gain Performed mixed signal analysis on Phase lock loop with analog and digital circuits and developed technique to reduce analog power supply noise.
Years of Experience
Experience
10+ Years
Experience Level
Level
Senior
Education
Education
Information Technology


RF Engineer III Resume

Summary : An aspiring Senior Telecommunication Engineer committed to professionalism; highly organized, work under strict deadline schedules with attention to detail and have excellent analytical skills.

Skills : Motivated, Good prasanter.

Description :

    1. Monitored the values of RSRP, RSRQ, SNR, and DL & UL throughput values, and try to enhance the signal in the bad coverage areas.
    2. Used Actix, COPS, QUANTUM and Business Object to analyze the reasons and created the cluster reports with the recommendations of antenna tilting, neighbors missing, and the low RSRP value areas to reduce the call drop rates and meet the client specifications.
    3. Utilized ATOLL RF Planning tool for generating new LTE RF designs, also utilized MapInfo and Google Earth to convert, analyze and present RF data, maps and plots.
    4. Optimize RF design by ATOLL tool and manual fine-tune, identify and improve problem areas in terms of coverage, interference and service quality.
    5. Log analysis of drop calls and access failure issues.
    6. Evaluated problems with SHO, IRAT failures and IFHO and recommended appropriate solutions.
    7. Generated scripts for missing neighbors and forwarded it to client RF Engineer for OSS entry.
    8. Recommended Azimuth and tilt changes to reduce pilot pollution and increase coverage area.
Years of Experience
Experience
7-10 Years
Experience Level
Level
Management
Education
Education
Computer Systems


RF Engineer Intern Resume

Headline : Highly qualified RF Engineer with experience in the industry. Enjoy creative problem solving and getting exposure on multiple projects, and the collaborative environment on which your company prides itself.

Skills : Python, Java, Project Management, Leadership Development, IT and Electronic equipments Sales.

Description :

    1. Performance and is accountable for the successful delivery of network planning and optimization activities for mobile telecommunications networks.
    2. Hands-on experience in using RF planning and optimization tools.
    3. Identified network trends and abnormalities and proactively take steps to prevent performance impacts on network traffic and end customer.
    4. Measuring Network Vision KPIs and performance impacts after legacy sites are migrated to Network Vision and ensured to make necessary changes and submittal of No-harm reports within 48 hours to Sprint for approval.
    5. Monitored the day to day stats in tools like Mobile Meridian, Samsung Viper, Spotfire, BSM, and LSMR for 3G/4G for any worst offenders and notified the respective teams to get them addressed.
    6. Proactively took a lead and worked on sites/sectors reporting zero calls and top offenders for the 3G/4G network.
    7. Responsible for High-Level Optimization Using WindCatcher and XCAP for the Clusters.
Years of Experience
Experience
5-7 Years
Experience Level
Level
Executive
Education
Education
Electrical Engineering

RF Engineer Technician Resume

Objective : To be a consistent, hard and smart professional worker and be associated with a progressive organization that gives me scope to efficiently utilize knowledge and skills in accordance with latest technology.

Skills : Ibwave.

Description :

    1. Using knowledge of RF propagation fundamentals, performed engineering design of all cell site specifications for the intended coverage area.
    2. Utilized RF Propagation and GIS Tools such as Planet, MapInfo and Google Earth for analysis and reporting.
    3. Utilized network monitoring tools and data collection databases to optimize the performance of the RF network and subscriber devices.
    4. Oversaw the RF engineering requirements as part of a large team that successfully completed the live conversion of the Hawaii market from the proprietary network to the final WiMAX standard technology.
    5. Gave direction and critical decision points in weekly project management meetings to ensure that target delivery dates were met and performance levels were achieved.
    6. Responsible for all network traffic issues such as congestion, packet loss and service availability.
    7. Directed the market Field Technicians to collect diagnostic drive data to help identify network device problems before they become service impacting.
Years of Experience
Experience
2-5 Years
Experience Level
Level
Junior
Education
Education
Computer Science

RF Engineer Specialist Resume

Summary : Driven technical professional with background in handset tools from different vendors. Proven ability to plan, schedule and implement multiple deadline driven projects. Experienced wireless communications professional and great Inter-personnel skills and good team spirit.

Skills : 4G, 3G GSM, EVDO, EDGE, CDMA, UMTS, LTE, eNB Optimization.

Description :

    1. Maintained and updated relevant databases (Planet EV, Siterra, Optimization databases ) with RF fields as required.
    2. Evaluated potential candidates using Planet EV or other propagation prediction tools.
    3. Conducted CW tests taking into consideration the Link Budged as well as importing the data into Planet EV for further analysis.
    4. Provided Site Acquisition support by approving candidate, visiting sites, preparing RF support documents, reviewing lease exhibits, and construction drawings.
    5. Provided RF support and accurate technical testimony at all site related hearing for zoning boards, planning commission, and board of trustees.
    6. Requested inter-modulation and completed RF NEPA analysis for all proposed sites in addition to ensuring FCC compliance and appropriate signage posting.
    7. Conducted site audits after the construction phase and identified site issues according to Cricket's guidelines.
Years of Experience
Experience
7-10 Years
Experience Level
Level
Management
Education
Education
Master Of Science

RF Engineer III Resume

Headline : Microwave path and site locations and height measurements using survey equipment provides accurate data for Pathloss 5 inputs to calculate clearances along the path for FCC licensing. Microwave physical path surveys, Site Surveys, P-P Link and P-M-P coverage analysis, UHF/VHF P-M-P coverage calculations, Microwave Backhaul Engineering for Wimax/4G Rings, Access Ring, Spurs, IP Packet for sites up to 575Mb at client defined oversubscription rates.

Skills : Microsoft Office, Spectrum 959, MI Technologies, Agilent, HP.

Description :

    1. Desktop surveys using Pathloss 5 and Google Earth.
    2. Engineering microwave path and radio link calculations using Pathloss 4 for RESCUE 21 Coast Guard project.
    3. Identify existing transmitters and receiver characteristics and antennas for intermodulation studies.
    4. Determine risky sites due to existing transmitter equipment that may cause problems for VHF receivers.
    5. Make Microwave Transmission System field surveys and Path Calculations.
    6. Survey existing client sites to determine existing equipage and parameters for replacement system equipment.
    7. Microwave system engineering including multiplex and drop interfaces, orderwire, alarm equipment, power systems, and grounds.
Years of Experience
Experience
5-7 Years
Experience Level
Level
Executive
Education
Education
Diploma

RF Engineer II Resume

Summary : Experience using test equipment such as spectrum analyzers, oscilloscopes, signal-generators.

Skills : Network Analyzer, Spectrum Analyzer, Signal Analyzer, Signal Generator.

Description :

    1. Design, test and assemble a wireless vital sign Doppler radar system on PCB board at 5.8GHz and provide the prototpye for the company.
    2. Reduce the final product size 40% by an innovative phase array antenna design and a miniature wide bandwidth branchline coupler.
    3. Power cost reduced 50% by an adaptive power control system design.
    4. Perform VNA and anechoic chamber measurement for the antenna.
    5. Design and Implement the meander inverted-F antenna for 2.4GHz WIFI/Bluetooth application.
    6. Develop the algorithm for the target distance and multiple vibration sources detection with the beam-steering antenna.
    7. New algorithm simplifies the radar system design as well as performance improvement.
    8. Order the commercial parts and contact fab house for customized the package parts.
Years of Experience
Experience
7-10 Years
Experience Level
Level
Consultant
Education
Education
Computer Engineering

RF Engineer I Resume

Summary : A creative professional with a background in customer service, technical support, digital media, content creation and management. Accomplished in troubleshooting complex systems in an enterprise environment and well versed in a wide array of technical and creative systems.

Skills : IT, Database Management, Windows, File Maintenance, Helpdesk, IT Support.

Description :

    1. Installing Cell Site Router configurations and correcting configurations by remote access through Cisco Routers.
    2. Troubleshooting the configurations of various elements on individual cell sites that cause poor performance.
    3. Remote access to cards on sites though a UNIX interface for trouble resolution.
    4. Escalation of cell site outages to NTAC and Samsung for site correction and proper network function.
    5. Work remotely with field engineers in order to correct issues causing site outages and element failures.
    6. Monitor network performance and correct site issues that cause blocking and dropping.
    7. Chosen to offshore workload and work responsibilities to Mexico, designed training material for handoff.
Years of Experience
Experience
7-10 Years
Experience Level
Level
Management
Education
Education
Business Administration

Asst. RF Engineer Resume

Summary : Over 6+ years of Experience in Telecommunication & Wireless Industry Expertise in optimization and improving the coverage Expertise in Samsung Tools LSMR, BSM, Map Info Expertise in Handling of Hardware and maintaining the performance and load balancing Expert in optimization drive, Cluster, Pre Optimization & Post Optimization.

Skills : Office Procedures, Research, Research.

Description :

    1. Drive test for the initial installation with test frequency.
    2. Drive tests with commercial frequencies and collect data across the coverage area.
    3. Check for Handovers within the sectors and neighboring sites.
    4. Edge pre optimization drive and Post Optimization drive.
    5. Cover all the areas, collect data, and check for interfering frequencies.
    6. Optimization drives and provides the reports to an RF engineer.
    7. Work closely with RF Engineer to provide the summary and RF Conditions.
Years of Experience
Experience
7-10 Years
Experience Level
Level
Management
Education
Education
Project Management

Associate RF Engineer Resume

Summary : Hands on experience in conducting RF projects from planning, designing, tuning/optimization, to integration, RF Data Sheet, understanding of design of GSM, UMTS, LTE technologies, knowledge of analyzing Data Sheet designs and implementing the changes to improve the network performance when needed.

Skills : Microsoft Office, Spectrum Analyzer, Matlab, Autocad, IBwave Design, Creo Pro/e, Solidworks, PIM testing.

Description :

    1. Designed, optimized and grew the wireless network.
    2. Submitted documents for FCC and to corporate for compliance of the transmission sites.
    3. Administered the cell site database and propagation tool.
    4. Supervised drive test and construction teams as well as tools and equipment evaluation.
    5. Participate in projects from the design, equipment recommendations and implementation phases for active and passive In-Building DAS systems.
    6. Active system design process developed with LGC equipment.
    7. Performed CW test and tuned propagation models based on collected data on PlaNet software tool; administered PlaNet NT workstations.
Years of Experience
Experience
10+ Years
Experience Level
Level
Senior
Education
Education
Electrical Engineering

Lead RF Engineer Resume

Objective : To obtain an advance and challenging position utilizing proven abilities developed through my experience and education. Seeking for an opportunity to work as a RF Engineer or RF Optimization engineer in wireless industry, utilizing background and experience in Telecom Industry with a professional growth based on merit and performance.

Skills : UTRAN, RF, Leadership Development.

Description :

    1. Optimization of Network through field and KPI Optimization.
    2. Involvement in swap projects and managing the team for field test and tunining the physical parameter as per the requirement for both GSM and UMTS.
    3. Preperation of reports of the New swap and On-aired sites and getting approval from the customer.
    4. Handling the customer complaints through Icare in more professional way to deliver customer satisfaction.
    5. Responsible for handling Customer Level support tickets from RF end.
    6. Resolution of all RF related issues that the customer raised tickets for.
    7. Checking from end to end for solution and coordinating with other departments if the issue was non-RF related.
Years of Experience
Experience
2-5 Years
Experience Level
Level
Junior
Education
Education
Bachelor Of Science

RF Engineer Resume

Objective : 5+ Years of experience as an RF Engineer. Pre and post launch performance data collection, verification and optimization. Support trainee engineers to develop their Planning/Optimization engineering skills Analyze the cluster drive data to optimization solutions for technologies.

Skills : Auto cad, Surveying, Technical Writing, Network Administration.

Description :

    1. Performing post-processing optimization changes and tracking improvement towards target KPIs.
    2. Maintaining the Compliance between Golden Parameter List and the Network parameters.
    3. Performing IRAT analysis to decrease the IRAT rate towards the national level threshold.
    4. Performing HO analysis to improve the HO success rate towards the national level threshold.
    5. Identifying and tracking top-offenders/Silent sectors to fixing the issues.
    6. Implementing the Ericsson/NSN Fax flashes market wide with AMOS scripting and NSN Plan provisioning.
    7. Performing Neighbor audits, parameter audits to identify non-compliant sites in the market.
Years of Experience
Experience
2-5 Years
Experience Level
Level
Junior
Education
Education
Masters In Science